Datcom; Usb - Fronius Symo Advanced 10.0-3 208-240 Manual De Instrucciones

DATCOM

Check the data communication, entry of the inverter number, protocol settings
Setting range
Status
Displays data communication available via Fronius Solar Net or an error that occurred in
data communication
Inverter Number
Number setting (address) of the inverter in a setup with multiple inverters
Setting range
Factory setting
IMPORTANT! Each inverter must be assigned its own address when using multiple in-
verters in a data communications system.
Protocol Type
Defines the communication protocol used to transmit data:
Setting range
Factory setting
* The interface protocol type only functions without a Fronius Datamanager card. Existing
Fronius Datamanager cards must be removed from the inverter.

USB

Performing firmware updates or saving inverter detail values on a USB thumb drive
Setting range
Safely remove hardware
To remove a USB thumb drive from the USB A socket on the data communication rack
without losing data.
The USB thumb drive can be removed:
-
-
Software Update
For updating inverter firmware using a USB thumb drive.
Procedure:
Deactiv. WLAN AP?
WLAN Access Point
[not available]
Is displayed if no system monitoring is available on the inverter.
Status/inverter number/protocol type
00 - 99 (00 = inverter address 100)
01
Fronius Solar Net / Interface *
Fronius Solar Net
Safely remove hardware / software update / logging interval
When OK is displayed
When the "Data Transfer" LED is no longer flashing or lit
To deactivate the WLAN Access Point Press the Enter
key
35