Hilti DSH 600 Manual página 39

Ocultar thumbs Ver también para DSH 600:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
2. Fit the protective cap to the end of the water connection hose.
3. Disconnect the connector between the pump and the tool.
4. Release the three fastening screws on the pump and then remove the pump.
5. Fit the pump cover on the tool, insert the three retaining screws and tighten the screws securely
(tightening torque: 4 Nm).
5.2.5 Fitting the wheel set (accessory)
1. Slacken the two bottom securing screws on the metal guard.
2. Secure the base plate with the two screws.
3. Secure the wheels and washers with the screws on both sides of the base plate.
6 Operation
6.1 Starting the engine 7,
DANGER
Risk of asphyxiation. Carbon monoxide, unburned hydrocarbons and benzene in the exhaust gas
may cause asphyxiation.
▶ Don't work in closed rooms, trenches or pits and make sure the area is well ventilated.
WARNING
Risk of burning injury. The exhaust system gets extremely hot when the engine is running. It stays
hot for a long time after the engine is switched off.
▶ Wear protective gloves and avoid touching the exhaust system.
▶ Do not lay the product down on flammable material while hot.
WARNING
Risk of injury. A damaged exhaust system will raise the noise level above the permissible limit and
thus cause hearing damage.
▶ Never use the product if the exhaust system is damaged, missing or if it has been tampered with.
CAUTION
Risk of burns or injury through pinching the fingers when the water pump is fitted. Touching the
pump housing can cause burning injuries.
▶ Hold the forward grip only at the top and on the left side.
1. If the following equipment exists, also take this action:
DSH 600
▶ Press and hold down the throttle safety grip.
▶ Press and hold down the throttle trigger.
▶ Move the start/stop switch to the "start" position.
▶ Release the throttle safety grip and throttle trigger.
◁ The half-throttle position is activated.
▶ Squeeze the primer bulb 2 to 3 times until the primer bulb is completely filled with fuel.
Printed: 30.03.2017 | Doc-Nr: PUB / 5341995 / 000 / 00
All manuals and user guides at all-guides.com
6
8
English
31

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dsh 600-x

Tabla de contenido