9
installations.
See chapter 10 for the extended parameter display mode.
Setting obstacle detection sensitivity
Low motor torque:
N.B.: only use these settings if the medium motor torque values are not suitable for the installation.
Medium motor torque. Recommended setting for adjusting force settings correctly.
Maximum motor torque. May only be used if the door is equipped with a sensing edge.
Automatic closure after pause time (from door completely open)
Disabled.
reached, the door remains open.
Setting automatic closing time
The timer starts from the door open state and continues for the set time. Once the set time is
reached, the door closes automatically. The timer count restarts if a photocell is triggered.
Pause time settable from 00 to 90 s.
Pause time settable from 2 to 9 min.
Automatic door closing after mains power outage
Disabled. The door does not close automatically when mains power is restored.
rameter
Setting motor stop distance
Flashing warning signal for 1 to 10 seconds prior to every manoeuvre.
Selecting step mode control function
40
in extended mode).