Commands And Accessories - Roger Technology B70/1B Instrucciones Y Advertencias Para El Instalador

11

Commands and Accessories

the parameters ,
CONTACT
6(SC) 7(COM)
6(SC) 10(COM)
8(LAM) 7(COM)
9(+24V) 10(COM)
11(FT1) 10(COM)
12(COS) 13(COM)
14(ST) 13(COM)
15(PP) 13(COM)
16(CH) 13(COM)
17(COR) 18(COM)
20(ES) 19(COM)
24 25(ANT)
RECEIVER CARD
48
and in the extended menu.
DESCRIPTION
Photocell test connection.
Set the parameter to enable the test function.
check that the contact changes state correctly.
WARNING! If contact 6-SC is used for the photocell test function, a overhead door open
indicator lamp cannot be connected.
eter
• . Photocell triggers only during door closure. Photocell is ignored during door
aperture.
• . Movement is reversed if the photocell is triggered during door closure.
• . The door opens when an open command is received if the photocell is
obstructed.
If the photocells are not installed, jumper the terminals 10(COM) - 11(FT1) or set the
parameters and
WARNING R90/F4ES, G90/F4ES or T90/F4S series photocells.
•
closure.
If the sensing edge is not installed, jumper the terminals 12(COS) - 13(COM) or set the
parameter .
The current manoeuvre is arrested if the safety contact opens.
N.B.:
N.B.
N.B.: do not make joints in cable.
The B70/1B control unit has two radio remote control functions by default:
•
•
.
.
).
).