Roger Technology B70/1B Instrucciones Y Advertencias Para El Instalador página 46

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 96
Enable safeguarded door closure/opening
command.
This function is
• the door receives a STOP command;
• the sensing edge is activated;
Disabled. The parameter
After a period of time set with parameter
ing light, regardless of the parameter
If the door is closed as a result of a step mode command, after a period of time set with parameter
then the door closes.
If the door is stopped by the obstacle detection system during a closure manoeuvre, the door closes
after a period of time set with parameter
If the door is stopped by the obstacle detection system during an opening manoeuvre, the door closes
after a period of time set with parameter
If the control unit detects a collision occurring in the same position 5 consecutive times, the function is disabled and the motor is set
to safety mode. The door will then complete the manoeuvre only when a command is received.
the motor is set to safety mode. The door will then complete the manoeuvre only when a command is received.
Setting safeguarded closure/opening activation time
Restoring factory default values
NOTE
• The display flashes after 4 s
• The default factory settings have now been restored.
N.B.: The values shown in the table are indicative only.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
46
enabled if:
is not displayed.
, and then closes the door.
+
P1
P2
-
x4 s
.
and
).
.
.
Warning! Restoring default settings cancels all settings
made previously: after restore, check that all parame
ters are suitable for the installation.
The default factory settings may also be restored using
Turn off the power.
,
), and
to
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

B70/pw

Tabla de contenido