Publicidad
Idiomas disponibles
Idiomas disponibles
&RXSH
&RQYHUWLEOH 'HFNOLG 'HFDO ,QVWDOODWLRQ
1.
Gently detach and remove the release liner from the decal and spray the
surfactant onto the exposed adhesive.
2.
Spray the surfactant onto the decklid and position the decal into place by
aligning the front edge to the decklid panel edge, the side to the masking
tape and at the rear slightly underneath the front edge of the spoiler.
3.
Use a squeegee to press the decal into place.
4.
Gently remove the premask carrier.
Coupe
&RQYHUWLEOH
Spoiler Decal Positioning
127( 7KUHH VSRLOHU RSWLRQV DUH SRVVLEOH ZLWK WKH &RXSH %DVH +3 RU
$FFHVVRU\ ZKLOH RQH RSWLRQ %DVH LV DYDLODEOH RQ WKH FRQYHUWLEOH
1.
Two spoiler decals have been included in the Coupe kit, one for use on the
base spoiler and one that can be used on both a H.P or Accessory spoiler.
2.
Select the decal that matches the spoiler option and position and tape into
place, aligning the outer edges to the installed decklid decal while assuring
that the front edge of the decal has enough material to wrap underneath the
front of the spoiler.
3.
Align masking tape through the center of the decal.
Decal-Spoiler
(D80)
Decal-Spoiler
(D52 & SB3)
RALLY Stripes
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
AUTH
REVISION
Spoiler Decal Installation
1.
Detach and separate one side of the decal from the release liner and gently
fold to the center tape "hinge".
2.
Use scissors to trim the release liner at the hinge. Remove and discard the
liner.
3.
Spray the surfactant onto the decal adhesive.
4.
Fold this portion of the decal back into position and use a squeegee to press
this portion into place.
5.
Remove Tape hinge and repeat Installation on opposite side of spoiler
(Scissors are not needed for installation of remaining decal).
6.
As the front edges of the decal extend beyond the edge of the panel, great
care should be taken during premask removal.
7.
Use a towel to carefully dry any surfactant that may remain along the edge
of spoiler and underneath the portion of the decal that extends beyond the
panel edge.
8.
Spray the wrapping solution onto the adhesive side of the decal.
9.
Use the heat gun to apply (for 3-5 seconds) direct heat along the length of
the decal.
10. Use a towel to press the decal around the panel edge while applying
additional heat as necessary.
11. Use the squeegee to press the decal between the spoiler and the decklid
into place.
12. Apply additional heat (as necessary) and press into place until the decal is
properly adhered.
PART NO.
IR 21FE14
INSTALLATION INSTRUCTIONS
DR
TITLE
PART NO.
23432805
23432805
SHEET
RALLY Stripes
3
SHEET
3
14
OF
14
OF
Publicidad
