Use - Locking The Height Adjustment Collar - Permobil BodiLink Head Support Operación Manual

USE - LOCKING THE HEIGHT ADJUSTMENT COLLAR

Locking the Height Adjustment Collar.
Note: The 3" hardware stem does not have a height adjustment collar.
1
Finish the setup by loosening the set screw (D) in the collar (A).
2
Slide the collar (A) onto the hardware stem (C) to meet the top of the mounting block (B).
3
Tighten the set screw (D) in the collar with the 2mm hex key until contact is made with the
hardware stem. This allows for the easy positioning of the hardware if it is removed and then
replaced.
Note: Collar (A) is retained in a track in the hardware stem (C). If the collar needs to be removed, remove the
set screw (E) located in the track at the bottom of the hardware stem with the provided 2mm hex key.
BodiLink Head Support Operation Manual
A
B
C
E
D
21
C
A