JMA EvoXpert Manual De Instrucciones página 24

4. CONNECTIONS: CONFIGURATION
SETTINGS MENU
After opening the Connections Menu (by clicking SETTINGS/CONNECTIONS),
you will see both the type of connection currently enabled and the various
parameters of that connection.
Both connection modes can be enabled regardless of the mode (Ethernet/
Wi-Fi) used to connect previously.
To switch modes, you just need to:
• Enable the new parameters on the connections page.
• Wait for EvoXpert to restart automatically so that the new
settings for either option are stored.
The image below shows the default connections that are configured by JMA
on all EvoXpert machines, for both Ethernet and Wi-Fi connections:
• Ethernet connection (wired LAN network). Mode = DHCP:
For a wired connection (via Ethernet), the IP address for the network to
which you have connected is obtained automatically.
That is what is meant by DHCP (Dynamic Host Configuration Protocol).
In this case, the assigned router address is the one shown on the left in the
image above. However, this will be different for each client.
• Wi-Fi connection (wireless Wi-Fi network). Mode = AP Mode. (Access
Point - AP Mode):
In this case, the EvoXpert machine creates a Wi-Fi network but does not yet
provide Internet access.
In this mode, the Wi-Fi network created lets you configure the network name
(SSID) and the Wi-Fi network password for the client router with Internet
access.
This address and the password are the same for all EvoXpert machines.
The main connection types for EvoXpert are explained below
24
4.1 ETHERNET CONNECTION (WIRED LAN NETWORK)
INIZIALIZING
CONNECTED!
Whenever the router can be accessed from wherever you choose to position
your EvoXpert machine, we recommend using an Ethernet cable between
the two devices as this provides faster communication, is much easier and
transfers data more quickly.
If the client's router is configured in DHCP mode (as the vast majority of rou-
ters are), the router itself will assign an IP address to your EvoXpert machine
for subsequent Internet access.
No additional configuration will be required.
You can access the EvoXpert web app by entering the name shown on the
label found on the bottom of your machine into any available web browser.
To make this easier (finding the EvoXpert on the network and accessing the
web app included with the device), specific apps have been developed for
(Android/iOS/Windows) that need to be installed and opened.
For the connection used in our example:
• PC with a Windows OS connected to the router via Wi-Fi.
• EvoXpert connected to the same router via an Ethernet cable.
From the indicated web address (www.jma.es, "downloads" section),
download the JMA KEY CLONING PRO setup file and install it on the PC with
a Windows OS.
If you are running JMA Key Cloning Pro for the first time, you will need to
configure the type of connection being used by the PC (Ethernet / Wi-Fi) in
the SETTINGS folder in order to connect to the router.
All the physical cards installed will appear in the Interfaces drop-down list,
as well as the virtual connections associated with that PC.
EVO
XPERT