Start-up
Safety
Danger from incorrect operation.
This can result in severe personal injury and damage to property.
▶
▶
▶
▶
Proper use
The charger is designed to charge the batteries listed below. Any use above and
beyond this purpose is deemed improper. The manufacturer shall not be liable
for any damage resulting from such use. Proper use also includes
-
-
Danger from charging dry batteries (primary cells) and non-rechargeable batte-
ries.
This may result in serious injury and damage to property.
▶
The following battery types may be charged:
-
-
-
Mains connec-
The rating plate, which is located on the housing, contains information about the
tion
permitted mains voltage. The device is designed for this mains voltage only. The
fuse protection required for the mains lead can be found in the "Technical data"
section. If there is no mains cable or mains plug on your version of the appliance,
fit one that conforms to national standards.
NOTE!
Danger from insufficiently dimensioned electrical installation.
This can result in serious damage to property.
▶
WARNING!
Do not use the functions described here until you have fully read and un-
derstood the following documents:
Operating Instructions,
all the Operating Instructions for the system components, especially the
safety rules,
Battery and vehicle manufacturer's Operating Instructions and safety rules.
following all the instructions contained in the Operating Instructions,
regular checking of the mains and charging leads.
WARNING!
Only charge the battery types listed below.
Wet batteries:
Sealed batteries with a liquid electrolyte (recognisable by the vent plugs) and
low-maintenance/maintenance-free wet batteries (MF).
Absorbent Glass Mat (AGM) batteries:
Sealed batteries (VRLA) with immobilised electrolyte (sealant).
Gel batteries:
Sealed batteries (VRLA) with immobilised electrolyte (gel).
The mains lead and its fuse must be dimensioned to suit the local power sup-
ply. The technical data shown on the rating plate applies.
55