Battery Changing Mode; General Information; Changing The Battery - Fronius Acctiva Smart 25 A Manual De Instrucciones

Ocultar thumbs Ver también para Acctiva Smart 25 A:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 173

Battery changing mode

General informa-
Battery changing mode supplies the vehicle electronics with power while the bat-
tion
tery is replaced. Before disconnecting the old battery from the vehicle electro-
nics, the charger leads must be connected to the vehicle battery leads. This con-
nection must remain in place until the new battery is connected.
Changing the
NOTE!
battery
Danger of incorrect voltage setting.
This can result in severe damage to the vehicle electronics.
1
3
NOTE!
Danger if the wrong battery voltage is set.
This can result in damage to property.
74
Always set the correct voltage after connecting the charger to the vehicle
battery leads.
Plug in charger mains plug
Select Battery changing mode using the up/down keys.
2
Connect the charging leads to the vehicle battery leads as described below -
the de-energised charging leads mean there are no sparks when connecting
the battery, even if the charger is already connected to the mains supply.
-
Connect the red charging lead to the positive (+) vehicle battery lead
-
Connect the black charging lead to the negative (-) vehicle battery lead
Always ensure that the correct battery voltage is set.
The charger automatically identifies
the battery, e.g. 12 V, and starts powe-
ring the vehicle electronics after 5 se-
conds.
If the battery voltage is not correctly
identified (e.g. usually the case if a bat-
tery is deeply discharged), you have 5
seconds to enter the correct battery
voltage as follows:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Acctiva professional 35 a

Tabla de contenido