Commissioning; Initial Commissioning - Bosch rexroth LU 2/P Instrucciones De Montaje

9 Commissioning

9.1 Initial commissioning

Danger from improper handling of hydraulic oils!
Improper handling of hydraulic oils can result in severe injury (or even death).

Observe all safety instructions in the manufacturer's safety data sheet
(see Table 1 on page 6)

Appropriate protective equipment must be worn when handling the product.
Sudden movements, falling workpiece pallets

Injuries caused by falling objects.

Make sure that the product has been installed properly by qualifi ed personnel
(see page 9) before starting it up.
Malfunctions due to incorrect assembly and commissioning
The product can get damaged, shortening its service life.

Commissioning requires basic mechanical, hydraulic, pneumatic and electrical
knowledge.

The product should only be commissioned by qualifi ed personnel
(see page 9).
• Before the initial commissioning or re-commissioning of a conveyor system, carry
out a risk assessment in accordance with DIN EN ISO 12100.
• According to EU Machinery Directive 2006/42/EC, you must equip the transfer
system with EMERGENCY STOP control devices.
• The surfaces of motors, gears and LU 2/P components mounted in their vicinity
can reach temperatures of over 65 °C under certain load and operating conditions.
In these cases, you must comply with the respective applicable accident prevention
regulations (UVV) by taking appropriate constructive measures (safety guards) or
by affi xing/displaying appropriate warning signs!
• Make sure that all electric, hydraulic and pneumatic connections are either being
used or are covered. Make sure that all bolted connections and plug-in connections
are properly seated and tight. All relevant protective covers must be fi tted.
• Only inspect and adjust continuous conveyors that are in motion or operation when
the protective equipment is in place.
• Observe DIN EN ISO 13857 when you remove or replace protective equipment
and/or bypass safety equipment.
• Test runs with open paneling should only be performed by a person with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.
• Only commission the product if all safety equipment has been installed in the
system and is ready for use.
• Only commission a product that has been completely installed.
• Before the initial start-up, ensure that there are no protruding or sharp-edged parts
that may be a hazard to personnel working or moving in the area.
WARNING
CAUTION
NOTICE:
3 842 557 976/2020-08, MIT: LU 2/P-24V-3L, Bosch Rexroth AG
Commissioning 33/42