Tabla de contenido
Publicidad
GB
IT
When the selector is in the "AUTO" position, boiler func-
tioning is automatically controlled on the basis of the
ES
temperature levels and time periods set. The second
selector must be in the "RUN" position to start.
PT
The programming procedure is described below:
FR
– Setting the time
Set the selector to the "CLOCK" position. Press "h" to
NL
change the hour on the display, or "m" to change the
minutes. To set the day, press the "1...7" button until
the arrow is pointing to the correct day (1 =
Monday... 7 = Sunday).
– Setting the program
The time clock has 8 on times and 8 off times. To
make it easier to use, the time clock is supplied with
3 on times and 3 off times already set for each day
of the week, as shown below:
Program
NOTE: No program is set from 7 through 17.
To select programmes other than those already set,
move the selector to position "P"; "0:001" will appear
on the display, in which the first three digits indicate
the hour and minutes, while the fourth digit identifies
the program number. Odd-numbered programs iden-
tify requests for operation (day temperature), in
which case the light bulb symbol will appear on the
display, while even-numbered programs identify
drops in temperature (night). Use the "1...7" key to
select the day of the week (from 1 to 7) or days (1 ÷
5, 6 - 7; 1 ÷ 6 or every day if the program is to be
repeated every day of the week). Set the hour and
minutes with the "h" and "m" buttons.
Press "P" to store the operation in memory and go
on to the next program. Repeat the same procedure
to set the remaining programs.
10
DIGITAL TIME CLOCK - Code 8092214
1
2
3
4
5
6
or
When finished programming, set the selector to
"RUN" position.
– Deleting one or more programs
The on and off time must be deleted for each pro-
gram to be deleted.
Set selector (2) to position "P". Select the desired
program with button (3), then press button (4) to
delete the day setting (the triangular symbols for the
days should go away). If part of the program is dele-
ted, when you set selector (2) back to the "RUN"
position an error will appear in the clock display,
referring to the program which is incorrect.
To delete all programs, put the selector in position
"P" and press buttons (3) and (5) at the same time.
– Setting the SKIP function
The SKIP function deactivates programs for the next
day and resumes regular programming 24 hours
later.
This function is useful if you will be out all day and
don't need heating.
Time
To start this function, press button (7), which is acti-
ve only when selector (2) is in "RUN" position.
06,00
Once you have selected the SKIP function, it will go
09,00
12,00
into effect at 0:00 of the next day for 24 hours.
14,00
You cannot turn it off once it has started, so regular
18,00
programming will not resume until 24 hours have
22,00
passed.
1 Manual/automatic operation selector
2 Program/schedule setting selector
3 Program button
4 Day of the week button
5 Hour button
6 Minute button
7 SKIP button
8 Reset button
Publicidad
Tabla de contenido
