Carburetor Adjustment Ajuste Del Carburador - Maruyama MIP2534S Manual Del Propietário

Tabla de contenido

Publicidad

CARBURETOR ADJUSTMENT
AJUSTE DEL CARBURADOR
Idle Speed Adjustment
This water pump is equipped with non-adjustable
fuel mixture carburetor. The engine idle speed is the
only adjustment accessible to the Operator.
CAUTION:
The water pump impeller is spinning during idle
speed adjustment.
Never start the engine without water in the pump
housing.
Running the engine without water in the pump
housing will cause serious damage.
Ajuste de la velocidad mínima
Esta bomba de agua está equipada con un
carburador de mezcla de combustible no ajustable.
La velocidad mínima del motor es el único ajuste
accesible al usuario.
PRECAUCIÓN:
El impulsor de la bomba de agua está girando
durante el ajuste de la velocidad mínima.
Nunca arranque el motor sin agua en el cuerpo de
la bomba.
De hacerlo así, provocaría graves daños.
IDLE SPEED ADJUSTMENT SCREW
TORNILLO DE AJUSTE DEL RALENTÍ
Engine Idle Speed :
The engine idle speed should be 2,700-3,300 rpm.
The engine idle speed is adjusted by rotating the
idle speed screw on the carburetor.
Turning the idle speed screw in (clockwise) increase
engine speed while turning the screw out decreases
engine speed.
Velocidad minima del motor :
La velocidad mínima del motor debería ser 2.700-
3.300 rpm.
Se regula girando el tornillo de ajuste del ralentí en
el carburador.
Si gira el tornillo en el sentido de las agujas del
reloj, aumentará la velocidad del motor; mientras
que si lo hace en sentido contrario, la reducirá.
- 34 -

Publicidad

Tabla de contenido
loading

Tabla de contenido