Energy Saving Tips; Induction Cooktop - Franke FH 604-1E 4I T PWL Instrucciones Para El Uso E Instalacion

ENERGY SAVING TIPS

INDUCTION COOKTOP

Hob control elements
Hob control
User interface initial
calibration
Activating the hob
All manuals and user guides at all-guides.com
• When buying cookware be careful in selecting size: pot diameter usually refers to the
top edge of the dish, which is often larger than the dish bottom.
• Steam-pressure pots (economic pots), which use pressure in tightly sealed interior, are
especially economic, and save both time and energy. Shorter cooking time leaves more
vitamins in food.
• Always leave enough water in steam-pressure pots, otherwise it may result in
overheating which may damage both the pot and the hotplate.
• Always cover the cookware with lids of appropriate size.
• Use such dish size to accommodate the quantity of food to be prepared. If you use
excessively large pot for small amount of food, you will consume considerably more
energy.
1. Induction hotplate front left
2. Induction hotplate rear left
3. Induction hotplate rear right
4. Induction hotplate front right
5. Hob control panel
A. ON/OFF sensor
B. Sensor (+)
C. Hotplate selection
D. Key lock ON/OFF sensor
E. Sensor (-)
• After turning the induction hob on all displays come on for a moment. The hob is ready
for operation.
• The hob is fitted with electronic sensors which are switched on if you touch the relevant
circle for at least one second.
• Each sensor activation is followed by a sound signal.
• Avoid placing any objects on sensor surface (The hob turns off after 10 sec.).
• Always keep the sensor surface clean.
The hob control panel has implemented an initial keyboard calibration focused to adapt
the sensibility of the keys, to the final mechanical, environmental and user conditions.
Any time the Cooktop is plugged or there is a power failure that generates a reset in the
user interface, the first time the Key Lock is touched the sensitivity of the keyboard is
readjusted. This first touch of the Key Lock must be done in certain conditions:
▪ Do not use gloves
▪ Use a clean finger.
▪ Touch the glass (smooth touching).
When the cooktop is connected to the power supply, the key lock is always and
immediately on. To turn the cooktop on, first of all you must remove the lock by pressing
the key (D).
21