Device Connection - FLAEM PRO LINE PulmoWaves 2 Instrucciones Para El Uso

A
A14
A11
A12
B2
B2
B
C2
C3
A1
O
C2
B1
15

Device connection

- Insert the coaxial cable plug (B4) coming out of (A5) into socket
(B3) of the nebuliser device.
- Insert the protective gasket (A14) into the power supply cable
plug (A12).
- Place the plug on power supply cable (A12) into socket (A11)
on the device A.
B3
Nebuliser device
B2.3 - Open the upper part (B2.2) of the nebuliser (B2) counterclock-
wise and pour the saline solution into (B.2.1).
- Apply the valve support (B.2.3) to the lower part (B.2.2).
B2.2
- Close the nebuliser (B2) of the Nebuliser Device B and connect
the connector (C3) and mouthpiece (C2) as shown in the con-
nection diagram.
B2.1
Use without nebuliser device
It is possible to use the Pulmowaves device without the nebu-
A9
liser, by closing the PEP fitting (C3) and with the valve (C5) as
shown in the picture.
A8
C5
A10
A4
Device activation
- Turn on the device by pressing power switch A1, then press
button B1 of the nebuliser.
- The compressor will start only with the patient's inhalation
mbar
through mouthpiece C2.
I – +
timer