FLAEM PRO LINE PulmoWaves 2 Instrucciones Para El Uso página 18

A13
A10
A9
B4
C4
CLEANING, SANITISATION, DISINFECTION AND STERILISATION
Witch off the device before any cleaning procedures and always unplug the power cable from the socket.
DEVICE (A) and (B)
Use only a damp cloth with antibacterial soap (non-abrasive and with no solvents of any sort).
ACCESSORIES
B2
Accessories (A8-C2-C3-C4-C5-B2) and connection tubes (A7-A9-A10) are for personal, single-pa-
tient use to avoid any risks of transmitting infection.
Open the nebuliser (B2) by turning the upper part anticlockwise, remove the upper part as shown
in the figure.
NOTE: For sanitisation, disinfection and sterilisation operations the PEP C3 connector must not
be disassembled.
ANTI-BACTERIAL FILTER
WARNING
- The filter (A8) is for single patient use and must be replaced as indicated on the package label.
- It cannot be washed, disinfected or sterilised and is not recyclable.
CLEANING AT HOME - SANITISATION AND DISINFECTION
SANITISATION
Before and after each use, sanitise the accessories and the nebuliser by choosing one of the methods described
below.
method A: Sanitise accessories (C1-C2-C3-C4-C5-A7-A9-A10-B2) under potable hot water (approximately 40°C)
with a gentle, non abrasive dish detergent.
method B: Sanitise accessories (C1-C2-C3-C4-C5) in the dishwasher with a hot cycle.
method C: Sanitise accessories (C1-C2-C3-C4-C5-A7-A9-A10-B2) by immersing them in a solution of 50% water and
50% white vinegar, then rinse thoroughly under potable hot water (approximately 40 °C).
If you want to also perform the cleaning for DISINFECTION, jump to the DISINFECTION paragraph.
17
Tube connector clip
Attach tubes (A9-A10) and cable B4 to the proper hooks of the
Clip A13 as shown in the detail.
Nose clip
- For the correct use of the PEP connector, the patient must put
on the nose clip (C4), as shown in the figure.