10. Servicing, Maintenance, Troubleshooting; Maintenance - Orbitalum GFX 3.0 Traducción Del Manual De Instrucciones Original

GFX 3.0, GFX 6.6

10. SeRVIcING, MAINTeNANce, TROUBLeSHOOTING

NOTe!
DANGeR!
DANGeR!
10.1

Maintenance

TIMe/INTeRVAL
Weekly
When cleaning and when
changing tools
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN
Servicing, maintenance, troubleshooting
Some of the work mentioned depends a great deal on the use and on the ambient conditions.
The cycles specified are minimum specifications. In individual cases, differing maintenance
cycles are possible. To ensure the safety of the machine, perform maintenance annually
using an authorized service center with VDE testing. If the machine does not function as
previously described, the machine must also be sent into an authorized service center.
Danger of death by electric shock!
Non-observance could result in death or serious injury.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug.
Risk of electric shock due to poor electrics!
Fatal electric shock.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug.
X Repair and maintenance work on the electrical equipment may only be carried out by a
qualified electrician.
AcTIVITY
X Remove the saw blade and use the
brush to remove any saw chips.
X Lubricate the 4 points indicated by the
arrows (use only thin-bodied oil, no
grease).
X Do not use compressed air to clean
the area at the end of the shaft (marked
with an arrow) as the rotary shaft seal
may otherwise be damaged by chips.
X Use a cloth or brush to clean the end of
the shaft.
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
69