Beveling Pipes; Cutting And Beveling Pipe Simultaneously - Orbitalum GFX 3.0 Traducción Del Manual De Instrucciones Original

GFX 3.0, GFX 6.6
IMPORTANT!
8. Set the desired speed level using the speed regulator (5) (for standard values, see chap. 9.2, p. 66).
9. Carefully turn the tube cutter in a clockwise direction until the tube wall has been pierced through.
10. Continue turning rapidly until the tube has been cut off and the marks (6) are aligned on the slide housing and body.
11. Turn the tube cutter back to its home position.
12. Switch the saw motor off again at the ON/OFF switch (4).
NOTe!
2
3
9.4

Beveling pipes

The necessary work steps for beveling pipes are identical to chap. 9.3, p. 66.
9.5

cutting and beveling pipe simultaneously

The necessary work steps for simultaneously cutting and beveling are identical to chap. 9.3, p. 66. The pipe cutter however must
revolve much slower around the pipe than when cutting, since two tools are being used at the same time.
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN
• Apply saw blade lubricant to teeth of saw blade.
• Repeat lubrication every 3 cuts.
• Only use saw blade lubricant/paste (no oils) from Orbitalum
Tools (e.g. GF LUB or GF TOP).
• Keep the machine clean.
• Always remove lubricant residues from the machine.
• The clamping area of the clamping jaws must be free of dirt,
chips and lubricants.
For continuous operation:
After cutting loosen the hexagon nut on the bevel cutter to avoid damage caused by tension.
1
Operation
6
5
4
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
6
67