Inserting The Saw Blade/Bevel Cutter Combination Or A Bevel Cutter; Saw Blade Clamping Point 2: Fitting The Saw Blade - Orbitalum GFX 3.0 Traducción Del Manual De Instrucciones Original

GFX 3.0, GFX 6.6
8.4.2

Inserting the saw blade/bevel cutter combination or a bevel cutter

ATTeNTION!
1. Turn the tube cutter clockwise and upwards by 180°.
2. Tighten the locking screw (2).
3. Loose the nut (5) clockwise (left-hand thread).
4. Clean the saw blade shaft (1) and vicinity with a brush.
5. Place the saw blade/bevel cutter combination (3) or bevel
cutter (4) onto the shaft (1).
IMPORTANT!
6. Tighten nut (5) counterclockwise (left-hand thread).
7. Loosen the locking screw (2).
8. Turn the tube cutter clockwise and downwards to its home position.
8.5

Saw blade clamping point 2: Fitting the saw blade

IMPORTANT!
Only use saw blade clamping point 2 to cutting tube
elbows. If you want to cut or bevel tubes, use saw blade
clamping point 1 (chap. 8.4, p. 60).
NOTe!
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN
Flying parts/breaking tool!
Do not use the clamping disc (4) when using saw blade/bevel cutter combinations or bevel
cutters!
Put the saw blade/bevel cutter combination or bevel cutter onto the shaft so that the inscrip-
tion points to the machine. The toothing then points in the right direction.
Warning messages are used in these instructions to warn you of possible risk of death, injury
or damage to property. Always read and observe these warning messages! To ensure safe
setting up and mounting please read all the warning messages in chap. 2, p. 40 and chap.
8, p. 56 attentively.
Saw blades can only be fitted or replaced if no tube is clamped in the vice.
If necessary, remove the tube before fitting the saw blade.
Set-up and assembly
2
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
1
61