Inserting The Saw Blade; Adjusting The Tube Dimension; Setting The Tube Dimension With A Scale - Orbitalum GFX 3.0 Traducción Del Manual De Instrucciones Original

eNGLISH
Set-up and assembly
8.5.1

Inserting the saw blade

1. Loosen the nut (5) counterclockwise.
2. Clean the saw blade shaft (1) and vicinity.
3. Place the saw blade (3) and clamping disc (4) onto the shaft (1).
IMPORTANT!
4. Tighten nut (5) clockwise.
5
8.6

Adjusting the tube dimension

IMPORTANT!
NOTe!
8.6.1

Setting the tube dimension with a scale

1. Loosen the star knob (1).
2. Select the tube dimension on the scale (2).
3. Slide the star knob (1) in the direction of the arrow to the
desired tube dimension.
4. Tighten the star knob (1).
62
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
Put the saw blade onto the shaft so that the inscription points to the clamping disc and nut.
The toothing then points in the right direction.
Warning messages are used in these instructions to warn you of possible risk of death, injury
or damage to property. Always read and observe these warning messages! To ensure safe
setting up and mounting please read all the warning messages in chap. 2, p. 40 and chap.
8, p. 56 attentively.
X The steps for adjusting the tube dimension are identical for both saw blade clamping
points.
2
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN
GFX 3.0, GFX 6.6
1