Line Laser; What To Do If; Servicing/Customer Service - Orbitalum GFX 3.0 Traducción Del Manual De Instrucciones Original

eNGLISH
Servicing, maintenance, troubleshooting
10.1.1

Line laser

X Own maintenance work on the laser is not permitted.
X The laser is to be returned to the factory for any maintenance or repair work that may be required.
X It is not allowed to open, modify or to remove protective covers or housings except for battery change.
10.2 What to do if ...? – General trouble shooting
PROBLeM
The tube cutter will not turn.
The saw blade is not cutting and is
slipping through.
The saw blade is not cutting.
The tube is not cut concentrically.
The tube is not cut.
The motor does not start.
10.3

Servicing/customer service

For ordering spare parts, refer to the spare parts list.
For troubleshooting, please contact the branch responsible directly.
Please indicate the following details:
• Type of machine: Pipe cutting and beveling machine GFX 3.0 or GFX 6.6
• Machine no. (see type plate)
70
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
POSSIBLe cAUSe
The locking screw is tight.
Incorrect tube dimension.
The nut on the saw blade shaft is not
tight enough.
The saw blade has been inserted the
wrong way round.
The tube cutter has been incorrectly
flanged. The flange surfaces are
contaminated.
Pipe dimension not correctly set.
The clamping lever is not tightened.
The auto startup inhibitor is active
because the ON switch is locked.
GFX 3.0, GFX 6.6
ReMeDY
X Loosen the locking screw.
X Set the tube dimension correctly.
X Tighten the nut.
X Insert the saw blade so that the labeling
on the saw blade faces the tube cutter.
X Remove the tube cutter, clean the fixing
parts and flange surfaces, reflange
the saw.
X Adjust the bevel cutter to the tube
dimension (chap. 8.6, p. 62).
X Tighten the clamping lever.
X Release the locking button and press the
ON switch again.
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN