Fitting The Machine Onto The Workbench; Important; Mounting Directly On The Workbench Without Quick-Mounting Plate; Mounting On The Workbench With Quick-Mounting Plate With Screw Clamps - Orbitalum GFX 3.0 Traducción Del Manual De Instrucciones Original

GFX 3.0, GFX 6.6
8.1

Fitting the machine onto the workbench

IMPORTANT!

WARNING!
Mount the GFX; either:
• directly on the workbench without a quick-mounting plate (see chap. 8.1.1, p. 57) or
• on the workbench with a quick-mounting plate with screw clamps (see chap. 8.1.2, p. 57) or
• on the workbench with a quick-mounting plate without screw clamps (see chap. 8.1.3, p. 58).
In addition, mounting of the GFX saws is possible on the tripod (only GFX 3.0), on the pipe feeder or on the mobile workstation
(all available optionally, see chap. 3.3, p. 48).
8.1.1 Mounting directly on the workbench without quick-
mounting plate
Only possible with the GFX 3.0.
1. Mark and punch the bolt holes on the workbench. Use the GFX 3.0 as a template.
2. Drill Ø 13 mm (0.5") holes.
3. Fasten the GFX 3.0 with the supplied countersunk screws M10x70 (8.8) onto the workbench.
8.1.2

Mounting on the workbench with quick-mounting plate with screw clamps

Quick-mounting plates with screw clamps are not included in the scope of delivery of the GFX series and can be retrofitted (see
"Accessories", chap. 3.3, p. 48).
NOTe!
1. Fit the quick-mounting plate with the screw clamps onto the workbench.
2. Guide the tube cutter sideways onto the fitted quick-mounting plate.
3. Tighten the hexagon screw (2) so that it lies firmly on the retainer at the vice of the saw (3).
1
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN
Warning messages are used in these instructions to warn you of possible risk of death, injury or
damage to property. Always read and observe these warning messages! To ensure safe setting up and
mounting please read all the warning messages in chap. 2, p. 40 and chap. 8, p. 56 attentively.
The pipe cutters are top-heavy and can cause a workbench that is not
load-bearing and not secure against tilting to tilt!
Irreversible crushing and material damage.
X Mount pipe cutters only on stable, load-bearing and non-tilting workbenches.
At the GFX 6.6 the quick-mounting plate has to be mounted directly on the left-hand workbench
edge, so that the vice handle (1) at the side of the GFX 6.6 can be turned in its full radius with
sufficient distance to the workbench edge.
2
Set-up and assembly
2
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
3
57