Dismantling Barrel Assembly - Stanley 70510-01000 Traducción De Instrucciones Originales

E N G L I S H
Screw Piston Nut 47 and Lock Nut 46 onto the Thread of the Piston 41. Using Spanners*, lock the Nuts together,
•
ensuring that the front face of Locknut 46 is flush with the front face of Piston 41.
Fit Barrel Assembly 2, 11, 13, 20, 21, 23, 25, 31, 32, 33, 34, 35, 36, 37 to Body 38. Secure using Screw 3, lock screw
•
using Hexagon Wrench*.
• Fit Tail Jaw Housing 42 and Tail Jaw Assembly to Body 38 and tighten using Spanners*.

8.5 DISMANTLING BARREL ASSEMBLY

• Using hexagon Wrench*, remove Button Head Bleed Screws 1 and Seals 6 from Body 38.
Remove Barrel Assembly from Body 38.
•
• Using Hexagon Wrench*, remove Screw 2 from Barrel Nut 32. Replace "O" Ring 25.
Note: When Replacing Screw, secure using Locktite Screwloc 222.
With the aid of Spanners* hold Barrel 33 and remove Barrel Nut 32 using Spanners*.
•
• Remove Barrel Spring 36, Barrel Spring Retainer 35. Remove Spring Guide 21, remove Spacer 37 and remove Seal
Spring Guide 34. Remove "O" Rings 11 and 13.
• Clean and inspect all parts. Replace if damaged or worn. Assemble in reverse order.
* Refers to items included in the service kit, see page 16.
Item numbers in bold refer to the general assembly and parts list on pages 21-22.
20
O R I G I N A L I N S T R U C T I O N