Putting Into Service; Air Supply - Stanley 70510-01000 Traducción De Instrucciones Originales

O R I G I N A L I N S T R U C T I O N

4. PUTTING INTO SERVICE

4.1 AIR SUPPLY

All tools are operated with compressed air at an optimum pressure of 5 bar. We recommend the use of pressure regulators
and automatic oiling/filtering systems on the main air supply. To ensure maximum tool life and minimum tool maintenance,
these should be fitted within 3 metres of the air inlet point on the tool itself for the 70510 and Guard. See diagram below.
Air supply hoses should have a minimum working effective pressure rating of 150% of the maximum pressure in the system
or 10 bar, whichever is the highest. Air hoses should be oil resistant, have an abrasive resistant exterior and should be
armoured where operating conditions may result in hoses being damaged. All air hoses MUST have a minimum bore of 6.4
millimetres or 1/4 inch.
Read daily servicing details on page 15.
STOP COCK
(USED DURING MAINTENANCE
OF FILTER/REGULATOR
OR LUBRICATION UNITS)
LUBRICATOR
PRESSURE REGULATOR
AND FILTER
(DRAIN DAILY)
E N G L I S H
TAKE OFF POINT
FROM MAIN SUPPLY
MAIN SUPPLY
DRAIN POINT
9