Breville the Dual Boiler BES920 Manual De Instrucciones página 16

While 'rSEt' is displayed on the LCD, press
the MENU button to reset all settings
to factory defaults. Machine will beep to
confirm selection.
'Hrd3' will flash on screen. Machine is
now in Water Hardness mode. Determine
water hardness with the supplied water
hardness test strip. Refer to 'Setting Water
Hardness', page 10. Press UP or DOWN
arrow to the required setting from 'Hrd1'
(softest water) to 'Hrd5' (hardest water). Press
MENU button to set. Machine will beep to
confirm selection. Setting water hardness will
determine the regularity of the 'NEW FILTER'
alert which indicates when the water filter in
the water tank needs to be replaced.
Descale (dESC)
Select this feature to access the step by step
descale procedure on the LCD. Refer to
page 24 for the accompanying instructions.
16
Temperature Unit - ˚C/˚F (SEt)
Set units to metric or imperial. While 'SEt' is
displayed on the LCD, press MENU button.
Press UP or DOWN arrow to the desired unit.
Press MENU button to set. Machine will beep
to confirm selection.
Steam Temperature (StEA)
Adjust the steam boiler temperature ,which
in turn controls steam pressure. Lower steam
temperature to texture smaller volumes of
milk or to have more control. Increase steam
temperature to texture larger volumes of milk.
While 'StEA' is displayed on the LCD, press
MENU button. Press UP or DOWN arrow to
the desired temperature. Press MENU button
to set. Machine will beep to confirm selection.
Disable AUTO OFF (A OF)
Use this function to disable the Auto Off
feature. While 'A OF' is displayed on the LCD,
press MENU button. Press UP or DOWN
arrow to select off or on. Press MENU button to
set. Machine will beep to confirm selection.