First Use - Breville the Dual Boiler BES920 Manual De Instrucciones

FIRST USE

1. Ensure tank is filled with cold water.
You can do this by either opening the
top-fill water tank lid (push to open), or
by removing the water tank at the back
of the machine.
2. Check STEAM LEVER and HOT WATER
dial are in the CLOSED position.
3. Press POWER button to turn machine on.
4. The LCD will display 'Hrd3', prompting
you to set the water hardness level.
Programming this will determine the
regularity of the 'NEW FILTER' alert which
indicates when the water filter in the water
tank needs to be replaced.
Setting Water Hardness
• Remove the supplied water hardness
test strip from the wrapper.
• Dip the test strip into a sample of the water
you have filled the tank with. Wait for one
minute. The water hardness setting is
indicated by the number of red squares
displayed on the test strip e.g. 3 red squares
indicate a water hardness setting of 3.
• Press UP or DOWN arrow to the required
setting from 'Hrd1' (softest water) to 'Hrd5'
(hardest water). Press MENU button to set.
Machine will beep to confirm selection.
NOTE
If there is no selection within 5 minutes, the
machine will default to setting 'Hrd3'.
5. A pumping/vibrating sound will be heard
indicating empty boilers are being filled
with water for the first time. The LCD will
display the current boiler temperature as it
heats up.
10
6. After approximately 10 minutes, the
machine will reach the default operating
temperature (200˚F/93˚C) and all 4
buttons will illuminate. The machine is now
in STANDBY mode, ready for the next step,
'Flushing The Machine'.
POWER
NOTE
You will not be able to select the 1 CUP or 2
CUP functions; access the cleaning cycle in
the menu options; or activate the steam wand
until the machine has reached operating
temperature (STANDBY mode). The machine
will beep 3 times if one of these functions
is selected.
FLUSHING THE MACHINE
When the machine has
reached STANDBY mode:
1. Press 2 CUP button to run water through
the group head for 30 seconds.
2. Rotate HOT WATER dial to the OPEN
position to run water through the hot
water outlet. After 30 seconds, rotate HOT
WATER dial to the CLOSED position.
3. Lift STEAM LEVER to the OPEN position
to release steam through the steam wand.
After 30 seconds, lower the STEAM
LEVER to the CLOSED position.
4. Repeat steps 1–3 twice.
5. Re-fill water tank and empty drip
tray, if required.