Hot Water - Breville the Dual Boiler BES920 Manual De Instrucciones

2 CUP BUTTON
Press 2 CUP button once to extract a double
shot of espresso at the preset duration (30
seconds). The extraction will start using the
low-pressure pre-infusion.
The machine will stop after 30 seconds and
return to STANDBY mode.
TIP
To by-pass low pressure pre-infusion and
deliver water to the group head at full pump
pressure, press and hold the 2 CUP button.
Release button when the desired amount of
espresso has been extracted. This function can
be used when purging the group head.
MANUAL BUTTON
The MANUAL button allows you to control
the espresso duration/volume to suit your
preference. Press MANUAL button once to
start the espresso extraction. The extraction
will start using the low-pressure pre-infusion.
Press MANUAL button again to stop
extraction.
TIP
To manually control the low-pressure
pre-infusion duration, press and hold the
MANUAL button. When the required pre-
infusion duration is met, release button to
begin full pump pressure. Press MANUAL
button again to stop extraction.
12
STEAM
For instant steam, move STEAM LEVER to
OPEN position. The STEAM LED will illuminate.
To turn steam off, move STEAM LEVER to
CLOSED position. The machine will return to
STANDBY mode.
CAUTION: BURN HAZARD
Pressurized steam can still be released, even after
machine has been switched off. Children must
always be supervised.

HOT WATER

For instant hot water, rotate the HOT WATER
dial to OPEN position. The HOT WATER LED
will illuminate.
To turn hot water off, rotate the HOT WATER
dial to CLOSED position.The machine will return
to STANDBY mode.
NOTE
You cannot run hot water and extract espresso at
the same time.
NOTE
Hot water will cease to dispense after approx.
30 seconds. Depending on the size of your cup,
you may need to close, then re-open the HOT
WATER dial. See 'HOT WATER LED flashing',
page 18.