Breville the Dual Boiler BES920 Manual De Instrucciones página 18

HOT WATER LED flashing during heat-up
The machine will not reach operating
temperature (STANDBY mode) if the HOT
WATER dial is in the OPEN position. The
HOT WATER LED will flash. Move the HOT
WATER dial to the CLOSED position.
HOT WATER LED flashing
To ensure water is dispensed at the correct
temperature, hot water will cease to dispense
after approx. 30 seconds and the HOT WATER
LED will flash. Move the HOT WATER dial to
the CLOSED position.
Fill Tank
The machine will detect a low water level. The
LCD will display 'FILL TANK'.
Fill tank with cold fresh water. The machine
will not be able to make coffee or hot water
while the tank is empty.
Clean Me!
Indicates when 200 extractions have been
carried out since the last cleaning cycle. The
cleaning cycle cleans the shower screen and
back-flushes the group head. For information
on how to clean the machine, refer to 'Cleaning
Cycle', page 23.
18
New Filter
Indicates when the water filter in the water
tank needs to be replaced. For information
on changing the filter, refer to 'Replacing the
Water Filter', page 23. The regularity of this
alert is determined by the water hardness
setting (Hrd1-Hrd5) selected. For information,
refer to 'Setting Water Hardness', page 10.
Temperature flashing
Indicates when the machine is heating up or if
the temperature drops excessively during use.
TRANSPORTING AND STORING
We recommend draining both boilers
completely before transporting the machine
or storing for an extended period of time. This
procedure is also intended as an anti-freeze
measure in the event the machine is exposed to
extreme cold temperatures.