Introduction; Device Description - Scheppach Compact 8t Traducción Del Manual De Instrucciones Original

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts
• Application other than specified
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 13 / VDE0113 not being observed
Please consider:
Read through the complete text in the operating manu-
al before installing and commissioning the device.
The operating manual is intended to help the user to
become familiar with the machine and take advantage
of its application possibilities in accordance with the
recommendations.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and extend-
ing the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual package with the machine
at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and careful-
ly observed by all operating personnel before starting
the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
36 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description

1. Handle
2. Riving knife
3. Splitting column
4. Retaining claw
5. Hoop guard
6. Control arm
7. Handle guard
8. Control lever
9. Swivel table
10. Locking hooks
11. Supports
11a. M10x25 hexagonal bolt
12. Ventilation cap
13. Base plate
14. Wheels
14a. Wheel axle
14b. Washer
14c. Safety cap
14d. Split pin
15. Switch and connector
16. M10x60 hexagonal bolt with washer and hexago-
nal nut
16a. Stroke setting bar
17. Motor
a. Cotter pin
b. Retaining bolt
c. Rocker switch
d. Stop screw
e. Locking screw (stroke setting bar)
f. Cap nut (stroke setting bar)
A. Pre-assembled device unit
B. Control arms right/left
C. Operating manual
Only for compact 10t
18. Stop lever
19. Trunk lifter
19a. M12x70 hexagonal bolt with washer and hexag-
onal nut
www.scheppach.com