Storage; Transport - Scheppach Compact 8t Traducción Del Manual De Instrucciones Original

• Loosen the breather cap (12)
• Open the drain plug (g) at the bottom of the oil tank
so that the oil can run out.
• Close the drain plug (g) again and tighten it well.
• Refill with 4.8 l of new hydraulic oil using a clean
funnel.
• Screw the breather cap (12) back on.
Dispose of the used oil properly at a local used oil
collection point. Dumping used oil in the soil or
mixing it with waste is prohibited.
We recommend the following hydraulic oils:
• Aral Vitam gf 22
• BP Energol HLP-HM 22
• Mobil DTE 11
• Shell Tellus 22
• or equivalent.
Do not use other types of oil!
The use of other oils affects the function of the hydrau-
lic cylinder.
Splitter spar
The spar of the splitter must be lightly greased before
commissioning. This process must be repeated every 5
operating hours. Apply grease or spray oil lightly.
The spar must not run dry.
Hydraulic system
The hydraulic system is a closed system with an oil
tank, oil pump and control valve.
The factory-completed system must not be changed or
manipulated.
Check the oil level regularly.
An oil level that is too low will damage the oil pump.
Regularly check hydraulic connections and screw con-
nections for leaks – retighten if necessary.
Before starting the maintenance or checks, clean the
work area and have suitable tools at hand and in good
condition.
The time intervals cited here relate to normal operating
conditions. If the machine is subjected to heavier loads,
these times must be reduced accordingly.
Clean the machine cladding, panels and control levers
with a soft, dry cloth or a cloth that has been slightly
moistened with neutral cleaning agent. Do not use any
solvents such as alcohol or petrol as these may dam-
age the surfaces.
46 | GB
Keep oils and lubricants out of reach of unauthorised
persons. Read through the instructions on the con-
tainers carefully and follow them closely. Avoid direct
contact with the skin and wash off thoroughly after use.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
Wearing parts*: Riving knife, riving knife/riving spar
guides, hydraulic oil
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

12. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging. Cover the
electric tool to protect it from dust or moisture. Store the
operating manual with the power tool.

13. Transport

Transport by hand, Fig. 15
To transport the log splitter, the riving knife (2) must be
moved all the way down. Tilt the splitter slightly with the
handle (1) and support with the foot until the machine
tilts onto the wheels and can thus be moved away.
Transport by crane (Fig 16 and 16a):
Never lift on the riving knife!
Compact 8t (Fig. 16)
Attach the straps on both sides to the upper bracket of
the guardrails. Then carefully lift the machine!
Compact 10t (Fig. 16a)
Attach the belts to the holder on the left of the upper
hoop guard and to the holder on the right of the locking
lever. Then carefully lift the machine.
www.scheppach.com