Drain System; Connect Inlet Hoses; Clear Water Lines - Maytag MAT20PDFGW Instrucciones

DRAIN SYSTEM

4. Drain system can be installed using a floor drain, wall
standpipe, floor standpipe, or laundry tub. Select method you
need.
4a. Floor drain system.
For floor drain installations, you will need to remove the drain
hose u-form on end of drain hose.
Floor drain system requires a Siphon Break Kit (Part Number
285320). Minimum siphon break: 710 mm (28") from bottom
of washer. Additional hoses may be needed.
4b. Wall standpipe drain system
203 mm
(8")
See requirements for floor standpipe drain system.
4c. Floor standpipe drain system
990 mm
(39")
203 mm
(8")
Minimum diameter for a standpipe drain: 51 mm (2"). Minimum
carry-away capacity: 10 gallon (38 L) per minute. Top of standpipe
must be at least 990 mm (39") high; install no higher than 2.44 m
(96") from bottom of washer.
4d. Laundry tub drain system.
203 mm
990 mm
(8")
Minimum capacity: 20 gallon (76 L). The top of the laundry tub
must be at least 990 mm (39") above floor.
12
.
.
(39")

CONNECT INLET HOSES

Insert new hose washers (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
Washer Coupling
Connect Inlet Hoses to Water Faucets
1. Attach hose to hot water faucet. Screw on coupling until it is
seated on washer. Repeat process for cold water.
2. Use pliers to tighten the couplings an additional two-thirds
turn.
IMPORTANT: Do not overtighten or use tape or sealants on valve
when attaching to faucets or washer. Damage can result.
3. Secure drain hose to inlet hose with zip strap.

Clear Water Lines

Run water through both faucets and inlet hoses,
n
into a laundry tub, drainpipe, or bucket to get
rid of particles in the water lines that might clog
the inlet valve screens.
Check the temperature of the water to make
n
sure that the hot water hose is connected to the
hot water faucet and that the cold water hose is
connected to the cold water faucet.