Bluetooth & Usb Connection; Pulse Measuring Via Bluetooth Device; Use Of A Fitness App (Kinomap); Usb Charging Function - SPORTSTECH CX700 Manual De Instrucciones

11. Bluetooth & USB Connection
The device is Bluetooth compatible and has a USB socket. Users have different options:

PULSE MEASURING VIA BLUETOOTH DEVICE:

Measure your pulse using a Bluetooth-compatible sensor (pulse strap). To do this, start your workout
and switch on the corresponding heart rate monitor. The system automatically recognizes the device
and shows the measured data on the display.

USE OF A FITNESS APP (KINOMAP):

In addition to a device for pulse measuring, you have the option of connecting another Bluetooth-enabled
device (e.g. smartphone, tablet, television) to use the Kinomap app. To do this, activate the Bluetooth
connection and select the Kinomap app to connect to your training device while it is in stand-by mode.
Follow the instructions and you can start your training!

USB CHARGING FUNCTION:

You can use the integrated USB port on the right edge of the display to charge your smart device.
Simply plug in the data cable and the display will automatically supply power. This is only possible during
operation. No charging takes place in stand-by mode or when the device is switched off.
12. Care, Cleaning & Maintenance
WARNING! Risk of serious or fatal injuries due to electric shock!
• Before any cleaning work, disconnect the device completely from the electrical supply outlet!
• Never allow moisture to get on or into the power supply unit or the cable!
• Never open or repair the power supply unit or cable! In case of problems, contact the
customer service!
WARNING! Danger of injury and damage to property!
• Never use the device if any components are loose or damaged.
• If possible, tighten connections. If necessary, arrange for repair.
• In all cases of doubt, contact customer service.
CLEANING
Remove perspiration from your training device after each training session. Do this carefully with a
slightly damp cloth and mild soap. Do not use solvents. Regular cleaning will greatly increase the life
of your exercise equipment. However, DO NOT use liquids near the power supply, computer/display or
other electrical or electronic equipment. Damage caused by sweat or other liquids is not covered by
the warranty at any time.Also prevent liquids (such as drinks) from entering the exercise equipment or
computer during exercise.
MAINTENANCE
The exerciser is equipped with sealed bearings. Lubrication is not required.
CHECK THE FASTENINGS
Before each training session, check that the bolts and nuts are tight. Tighten if necessary.
CHECK THE COMPONENTS
Check the secure condition of the saddle, seat post, handlebars and pedals before each training session.
EN DE
47