Husqvarna MADSAW 525iDEPS Manual De Usuario página 12

• Keep the cutting teeth correctly sharpened.
Obey the instructions and use the
recommended file gauge. A saw chain
that is damaged or incorrectly sharpened
increases the risk of accidents.
• Keep the correct depth gauge setting.
Obey the instructions and use the
recommended depth gauge setting. Too
large depth gauge setting increases the
risk of kickback.
• Make sure that the saw chain has the
correct tension. If the saw chain is not
tight against the guide bar, the saw chain
can derail. An incorrect saw chain tension
increases wear on the guide bar, saw
chain and chain drive sprocket. Refer to
tension the chain on page 26 .
• Do maintenance on the cutting equipment
regularly and keep it correctly lubricated. If
the saw chain is not correctly lubricated,
the risk of wear on the guide bar, saw
chain and chain drive sprocket increases.
12
Safety instructions for the dielectric shaft
WARNING:
instructions that follow before you
use the product.
• The product is tested to meet OSHA
1910.269(j) standards.
• If the product is used within 11m (36 ft)
of electrical hazards, it must be used by
approved and qualified personnel only per
OSHA 1910.269(r).
• Untrained and non-professionals: Do not
use within 11m (36 ft) of electrical hazards.
• Clean and do the correct servicing on the
dielectric shaft to help keep the electrical
insulation properties.
• Keep the dielectric shaft clean and dry
when you do work around energized
electrical power lines. Oil or dirt decreases
the electrical insulation properties of the
dielectric shaft.
• Obey local regulations.
• The tool must be clean, dry, and work
correctly before use.
• Follow all company procedures.
• Use only approved dielectric bar oil.
To
Battery safety
WARNING:
instructions that follow before you
use the product.
• Only use the batteries that we recommend
for your product. The batteries are
software encrypted.
• Use the batteries that are rechargable as
a power supply for the related Husqvarna
products only. To prevent injury, do not
use the battery as a power supply for other
devices.
• Risk of electrical shock. Do not connect the
battery terminals to keys, screws or other
metal. This can cause a short circuit of the
battery.
• Do not use batteries that are non-
rechargable.
• Do not put objects into the air slots of the
battery.
• Keep the battery away from sunlight, heat
or open flame. The battery can cause
burns and/or chemical burns.
Read the warning
Read the warning
1744 - 008 -