Husqvarna MADSAW 525iDEPS Manual De Usuario página 25

• Cutting angle.
• File position.
• Round file diameter.
It is not easy to sharpen a saw chain
correctly without the correct equipment. Use
Husqvarna file gauge. This will help you to
keep maximum cutting performance.
Note:
To sharpen the cutters on
Refer to
page 25 for information about sharpening of
the saw chain.
To sharpen the cutters
1. Use a round file and a file gauge to
sharpen the cutting teeth.
Note:
Filing equipment and
Refer to
filing angles on page 31 for information
about which file and gauge that Husqvarna
recommends for your saw chain.
2. Apply the file gauge correctly on to the
cutter. Refer to the instruction supplied
with the file gauge.
1744 - 008 -
3. Move the file from the inner side of
the cutting teeth and out. Decrease the
pressure on the pull stroke.
4. Remove material from one side of all the
cutting teeth.
5. Turn the product around and remove
material on the other side.
6. Make sure that all cutting teeth are the
same length.
General information about how to adjust
the depth gauge setting
The depth gauge setting (C) decreases
when you sharpen the cutting tooth (A). To
keep maximum cutting performance you must
remove filing material from the depth gauge
(B) to receive the recommended depth gauge
Technical data on page
setting. Refer to
30 for instructions about how to receive
the correct depth gauge setting for your saw
chain.
A
To adjust the depth gauge setting
Before you adjust the depth gauge setting
or sharpen the cutters, refer to
information about how to sharpen the cutters
on page 24 , for instructions. We recommend
you to adjust the depth gauge setting after
C
B
General
25