Husqvarna MADSAW 525iDEPS Manual De Usuario página 24

• Guide bar length, in/cm. Information about
the guide bar length can usually be found
on the rear end of the guide bar.
• Number of teeth on bar tip sprocket (T).
• Chain pitch, in. The distance between the
drive links of the saw chain must align with
the distance of the teeth on the bar tip
sprocket and drive sprocket.
D
• Number of drive links. The number of drive
links is decided by the type of guide bar.
• Bar groove width, in/mm. The groove width
in guide bar must be the same as the chain
drive links width.
24
D
PITCH =
2
• Chain oil hole and hole for chain tensioner.
The guide bar must align with product.
• Drive link width, mm/in.
General information about how to sharpen
the cutters
Do not use a blunt saw chain. If the saw chain
is blunt, you must apply more pressure to
push the guide bar through the wood. If the
saw chain is very blunt, there will be no wood
chips but sawdust.
A sharp saw chain eats through the wood and
the wood chips becomes long and thick.
The cutting tooth (A) and the depth gauge
(B) together makes the cutting part of the
saw chain, the cutter. The difference in height
between the two gives the cutting depth
(depth gauge setting).
A
When you sharpen the cutter, think about the
following:
• Filing angle.
B
1744 - 008 -