California Proposition 65
Product liability
As referred to in the product liability laws, we
are not liable for damages that our product
causes if:
Safety definitions
Warnings, cautions and notes are used to
point out specially important parts of the
manual.
WARNING:
a risk of injury or death for
the operator or bystanders if the
instructions in the manual are not
obeyed.
CAUTION:
of damage to the product, other
materials or the adjacent area if the
instructions in the manual are not
obeyed.
Note:
Used to give more information that is
necessary in a given situation.
General power tool safety warnings
WARNING:
warnings and all instructions.
Failure to follow the warnings and
instructions may result in electric
shock, fire and/or serious injury.
Note:
Save all warnings and instructions for
future reference. The term "power tool" in
the warnings refers to your mains-operated
(corded) power tool or battery-operated
(cordless) power tool.
4
Safety
Used if there is
Used if there is a risk
Read all safety
•
the product is incorrectly repaired.
•
the product is repaired with parts that are
not from the manufacturer or not approved
by the manufacturer.
•
the product has an accessory that is not
from the manufacturer or not approved by
the manufacturer.
•
the product is not repaired at an approved
service center or by an approved authority.
Work area safety
•
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
•
Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power
tools create sparks which may ignite the
dust or fumes.
•
Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control.
Personal safety
•
Stay alert, watch what you are doing and
use common sense when operating a
power tool. Do not use a power tool while
you are tired or under the influence of
drugs, alcohol or medication. A moment
of inattention while operating power tools
may result in serious personal injury.
•
Use personal protective equipment.
Always wear eye protection. Protective
equipment such as dust mask, non-
skid safety shoes, hard hat or hearing
protection used for appropriate conditions
will reduce personal injuries.
•
Prevent unintentional starting. Ensure the
switch is in the OFF-position before
connecting to a power source and/or
battery pack, picking up or carrying the
tool. Carrying power tools with your finger
on the switch or energising power tools
that have the switch on invites accidents.
•
Remove any adjusting key or wrench
before turning the power tool on. A wrench
or a key left attached to a rotating part
1744 - 008 -