Publicidad
Idiomas disponibles
Idiomas disponibles
MOWER OVERLOAD PROTECTION
To prevent overload conditions, do not try to remove too much grass at one time. Slow
down your cutting pace or raise the cut height.
Your mower has built-in overload circuit protection. When the mower is overloaded, the
motor will stop and the overload icon on the LCD screen will blink. Refer to the section
"STATUS INDICATORS ON MOWER LCD SCREEN" in this manual. Remove the battery
pack from the mower. Check to see if grass has collected beneath the deck and clear it
if necessary, then install the battery and restart the mower.
BATTERY HIGH-TEMPERATURE PROTECTION
The battery pack will generate heat during operation. The heat dissipates more slowly
in hot weather. If the battery temperature exceeds 158°F (70°C) during operation, the
protection circuit will immediately turn off the mower to protect the battery pack from
heat damage. The overheat icon on the LCD screen will blink. Refer to the section
"STATUS INDICATORS ON MOWER LCD SCREEN" in this manual.
Release the bail switch, wait until the battery pack cools down to approximately 152°F
(67°C), then restart the mower.
43
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2160SP/LM2160SP-FC
Publicidad
