Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
There is
excessive
vibration.
The handle-
locking clamp
cannot be
closed in
position.
Mower is
difficult to be
pulled back
after the self
propel is turned
off.
Mower is
difficult to
maneuver when
mowing around
an object or
mowing back
and forth with
self-propel
turned on.
The motor
works but the
blade doesn't
cut the grass.
The LCD screen
fails to turn on /
light up.
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2160SP/LM2160SP-FC
CAUSE
◾
The cutting blade is loose.
◾
The cutting blade set is
unbalanced.
◾
The cutting blade is bent.
◾
The motor shaft is bent.
◾
The mower is set to cut too much
grass at once.
◾
The blade speed mode is not set
properly.
◾
The side rails are not fully
extended.
◾
The wheels are temporarily
locked.
◾
The wheels are temporarily
locked.
◾
The blade is not tightened to the
required torque.
◾
The safety button is depressed
for less than 1 second.
SOLUTION
◾
Tighten the outer nut.
◾
Balance the blade set following
the"SHARPENING THE BLADE".
◾
Replace the blade.
◾
Contact the service center.
◾
Raise the deck to a higher
cutting-height setting.
◾
Select the blade speed to a
lower setting.
◾
Fully extend the side rails, then
lock the clamp.
◾
Simply push ahead slightly or
raise the rear wheels and then
move the mower as desired.
◾
Turn off the self propel.
◾
Re-tighten the blade. The
recommended torque for the
blade bolt is 36-43 ft-lb
(49-59Nm).
◾
The LCD screen will turn on
after the safety button has been
depressed for 1 second.
57
Publicidad
