Descargar Imprimir esta página

Olimpia splendid ALYAS E INVERTER 9 Instrucciones Para El Uso Y El Mantenimiento página 66

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 133
STOP
a. Press the "ON/OFF" key (2) to stop the air conditioner.
If the AUTO mode is not wanted, the desired conditions can be selected manually.
When AUTO mode is selected, the fan speed does not have to be set; the fan speed is controlled
automatically.
3.4.13 - Functioning in Cooling/Heating/Fan only mode
START
Check that the unit is connected and is powered electrically.
a. Press the "MODE" key (1) to select the "COOL", "HEAT", or "FAN ONLY". mode.
b. Set the desired temperature by pressing the "TEMP" keys (4).
Normally the temperature is between 21°C and 28°C.
c. When the remote control is "OFF", press the "ON/OFF" key (2) to start the air conditioner.
d. Press the fan speed key (FAN "5") to select "AUTO", "LOW", "MED", or "HIGH".
e. When the remote control is "OFF", press the "ON/OFF" key (2) to start the air conditioner.
The FAN ONLY mode does not adjust the temperature, therefore, to select this mode, only perform the "a",
"c", "d", "e" phases.
STOP
a. Press the "ON/OFF" key (2) to stop the air conditioner.
If the AUTO mode is not wanted, the desired conditions can be selected manually.
3.5 - ADJUSTING AIR FLOW DIRECTION
Adjust the direction of the air correctly in order to prevent the flow of air from being annoying (figure 3) or
generating irregular temperatures in the room.
a. Adjust the horizontal and vertical slits using the remote control.
b. Press the key (3a) to activate operation of the vertical slits.
c. Press the key (3) to activate operation of the horizontal slits.
3.5.1 - Adjustment of the horizontal and vertical direction of air (high - low) (figure "29-30")
The air conditioner automatically adjusts the horizontal and vertical direction of air, depending on operating
mode.
Perform this function when the unit is operating.
• The
buttons will be disabled when the air conditioner is not operating (also when the
TIMER ON is set).
• Do not activate the air conditioner for long periods with the air downwards in cooling or
dehumidification modes.
Otherwise, humidity may form on the surface of the horizontal louvres, which could fall onto the
floor or furnishings.
• Do not move the horizontal louvres manually.
Always use the
malfunctioning occurs, stop the conditioner and re-start it.
• When the conditioner is switched on immediately after it has been switched off, the horizontal
louvres may not move for approx. 10 seconds.
• The angle of opening of the horizontal louvres must not be too small, since performance in
COOLING or HEATING mode may not be perfect for the flow of air that is too narrow.
• Never activate the unit with the horizontal louvres in closed position.
• When the conditioner is connected to the power supply (initial power supply), the horizontal
louvres may make a noise for 10 seconds. It is normal operation.
EN - 24
button. If directed manually, malfunctioning may occur. If louvre

Publicidad

loading

Este manual también es adecuado para:

Alyas e inverter 12