20 EN
ATTENTION
►
Do not tilt the water tank when install-
ing. The valve on the underside of the
water tank may be damaged.
►
Make sure that both holders on the up-
per edge of the water tank are inserted into
the recesses on the rear of the appliance.
Installing the strainer insert
(image A1)
1.
Turn the nib on the wall of the strainer
insert (6) towards the handle and install the
strainer insert into the strainer holder (7).
2.
Turn the inserted strainer a quarter-turn to
the left or right. The nib prevents the strainer
insert from falling out.
Removing the strainer insert
(image A1)
1.
Empty the strainer insert (6) as described
in the section Emptying/cleaning the strain-
er insert (page 23).
2.
Turn the the strainer insert (6) so that the
nib on the wall of the strainer insert is point-
ing towards the handle.
3.
Lift the strainer insert (6) out of the strain-
er holder (7).
Emptying the strainer insert
(image B1)
1.
Fold the retaining bracket on the handle
of the strainer holder to the front over the
edge of the strainer insert.
2.
Knock the used coffee powder out of the
strainer insert into the waste container.
3.
Fold back the retaining bracket on the
handle of the strainer holder and clean the
strainer insert as described in the section
Cleaning and care (page 23).
NOTE
►
Use a spoon if the coffee grounds do
not fall out.
Removing the strainer holder (image
1.
Turn the handle (8) of the strainer holder
(7) to the left until the handle is under the
symbol of the strainer holder mounting.
C1)
BEEM - Elements of Lifestyle
2.
Pull the strainer holder down out of the
strainer holder mounting.
Inserting the strainer holder
(image C2)
1.
Hold the strainer holder (7) using the
handle (8) under the
mounting (5).
2.
Push the strainer holder from below into
the strainer holder mounting.
3.
Turn the handle (8) of the strainer holder
(7) to the right until the handle is under the
symbol.
NOTE
►
While inserting, take care not to tilt the
strainer holder.
Making espresso/coffee
with coffee powder
General instructions
The deeper strainer insert (6a) can hold
coffee powder for 2 cups of espresso or one
large cup of coffee.
Use the shallower strainer insert (6b) for
preparing one cup of espresso/coffee.
Do not overfill the strainer insert. An over-
filled strainer insert cannot be inserted into
the appliance.
Remove any excess coffee powder on
the edge of the strainer holder in order not
to contaminate the seal of the strainer holder
mounting (5).
If you wish to brew two cups of Espresso
at the same time, put the cups next to each
other on the cup rest so that the lower open-
ings in the strainer holder fill one cup each.
Do not leave the appliance unattended.
Coffee dispensing does not stop automati-
cally.
Due to expansion of materials, clicking
noises may occur during operation. These
operating noises are completely normal.
of the strainer holder