BONFIGLIOLI Vectron ANG210 Manual Del Usuario página 115

Use the ENT key to switch to the CTRL sub-menu.
•
In the CTRL sub-menu, select the menu item "SetUP"
•
and confirm by pressing the ENT key.
• Use the ENT button to select parameter
Configuration
• Use the arrow keys to enter the number 110 or 410.
110: sensor-less control acc. to U/f characteristic
410: sensor-less, field-oriented control
Press the ENT key to confirm this message and in
•
order to continue the commissioning procedure.
If the setup was changed, "SEtUP" will be displayed again.
Press the ENT key to confirm this message and in order to continue the
•
commissioning procedure.
• After initialization, confirm the selected configuration by pressing the ENT
key.
NOTICE
Device damage possible
If the motor type is not entered correctly, the drive may be dam-
aged.
Observe the correct motor type.
•
Select the connected machine via parameter
•
Operation Mode
0 - Unknown
1 - Asynchronous
2 - Synchronous
3 - Reluctance
10 - Transformer
Enter the motor data indicated on the rating plate in the following param-
•
eters.
07/20
30.
The motor is not a standard type.
Three-phase asynchronous motor, squirrel cage
Three-phase synchronous motor
Three-phase reluctance motor
Transformer with three primary windings
No. Description
370 Rated Voltage
371 Rated Current
372 Rated Speed
Quick Start Guide ANG
369.
Motor type
Function
No. Description
374 Rated Cosinus Phi
375 Rated Frequency
376 Rated Mech. Power
ENT
GB
ENT
115