To prevent personal injury, always disconnect the Battery Pack before per-
forming any assembly, adjustment, or repair.
Inserting and Releasing the Battery
Pack
(Fig. 7)
Slide a charged Battery Pack 29 into the Bat-
tery Bay 21 until the Battery Pack 29 locks into
position.
Your tool is equipped with a secondary locking
latch to prevent the Battery Pack 29 from com-
pletely falling out of the Battery Bay 21, should
it become loose due to vibration.
To disconnect the Battery Pack 29, press the
Battery Pack Release Button 30 and slide the
Battery Pack 29 completely out of the Battery
Bay 21.
Fig. 7
21
1609B07947GTS18V-08 OSI 08-2022.indd 18
Assembly
Removing and Installing the Table
Insert
Removing the Table Insert
(Fig. 8)
1. Rotate the Table Insert Lock 37 clockwise.
2. Lift the Table Insert 12 by the front edge,
and lift it clear off the table.
Fig. 8
29
30
Installing the Table Insert
(Fig. 8, Fig. 9)
1. Position the Table Insert Tab 39 into the
pocket
.
2. Make sure the Table Insert 12 is seated prop-
erly, and secure it in place using the Table
Insert Lock 37.
Fig. 9
31
A
-18-
12
and place the Table Insert 12 down
12
39
37
B
8/3/22 2:44 PM