Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Excessive vibration.
Cannot make square cut
when crosscutting.
Cut binds, burns, stalls mo-
tor when ripping.
Cut not true at 90° or 45°
positions.
Blade Bevel Lock Handle
Elevation Wheel hard to
move.
Rip fence will not correctly
clamp to rails.
1609B07947GTS18V-08 OSI 08-2022.indd 63
Troubleshooting
Cause
Blade Bevel Lock Handle 3 not
tightened.
The Blade 32 is out of balance.
The saw is not mounted secure-
ly to the stand or workbench.
The Arbor Nut 53 not tightened
properly.
The Miter Gauge 14 is not
adjusted properly.
The Blade 32 is dull.
Warped board.
The Rip Fence 9 is not parallel
to the Blade 32.
The Riving Knife 24 is out of
alignment.
The bevel stops are not ad-
justed properly.
Blade Bevel Lock Handle 3 not
loosened.
Saw dust on the threads of the
Threaded Elevation Rod 113.
Undercarriage filled with saw
dust.
The Rip Fence 9 is not fully
seated on the Rails 10.
-63-
Corrective Action
See "Getting to Know Your
GTS18V-08 Table Saw" on page
13.
Discard the Blade 32 and use a
different Blade 32.
Tighten all mounting hardware.
See "Mounting the Table Saw"
on page 32.
Tighten the Arbor Nut 53. (See
"Changing the Blade" on page
21.)
See "Miter Gauge Adjustment"
on page 34.
Replace Blade 32. (See "Chang-
ing the Blade" on page 21.)
Make sure the concave or hol-
low side is facing DOWN, and
feed slowly.
See "Rip Fence Adjustments"
on page 34.
See "Adjusting the Riving Knife"
on page 37.
See "Adjusting 0° and 45° Posi-
tive Stops" on page 39.
See the "Blade Tilt Lock
Handle" explanation in "Getting
to Know Your GTS18V-08 Table
Saw" on page 13.
See "Cleaning" on page 59.
Frequently blow out any dust
that has accu mulated in the
undercarriage, motor, or blade
elevation gears.
Make sure that both ends of
the Rip Fence 9 are fully seated
flush against the Rails 10 before
trying to latch the Rip Fence
Lock Levers 56.
8/3/22 2:44 PM
Publicidad
