Cameo F2 FC IP Manual De Usuario página 14

DMX-STARTADRESSE EINSTELLEN (DMX Address)
Starting from the main display, press the rotary-push encoder to enter the main menu. Turn the
left encoder (SELECT) to select the menu item DMX Address (note the selection arrow on the left)
and confirm by pressing the encoder (ENTER). You can now configure the DMX start address as
required by rotating the encoder (the highest value depends on the selected DMX mode). At the
same time, the DMX start address following the selected start address plus the channel number
of the selected DMX mode is displayed (following Address). Confirm the entry by pressing the left
encoder (ENTER), this also automatically takes you back to the main display and the DMX operat-
ing mode is activated. The menu item for selecting the desired DMX mode can be reached directly
from the menu item DMX Address by pressing the middle rotary-push encoder (DMX mode); the
previously set DMX start address is automatically saved.
Turn encoder =
Change value
Press encoder =
Confirm value change (Enter)
SET DMX MODE (DMX Mode)
Starting from the main display, press the rotary-push encoder to enter the main menu. Turn the
left encoder (SELECT) to select the menu item DMX Mode (note the selection arrow on the left)
and confirm by pressing the left encoder (ENTER). Now you can select the desired DMX mode
by turning the left encoder. Confirm the selection by pressing the left encoder (ENTER), this also
automatically takes you back to the main display and the DMX operating mode is activated. Tables
with the channel assignment of the different DMX modes can be found in these instructions under
DMX CONTROL.
1CH DIM
2CH DIM 16Bit
2CH CCT
3CH RGB cal.
4CH Direct
4CH CCT 16Bit
6CH HSI-CCT
7CH RGB-CCT
8CH Direct 16Bit
10CH HSI-CCT
16CH Direct CCT
14
Press encoder =
DMX mode selection (DMX Mode)
Press encoder =
Open main menu (Menu)