Sony KL-X9200J Manual De Instrucciones página 6

St abilizing t he m onit or
Using t he bracket s
After setting up, secure the monitor to a wall, etc. with
the supplied brackets.
1
M ount t he t w o supplied bracket s w it h t he
screw s t o t he upper rear sides of t he
m onit or.
2
Pass a st rong cord or a chain t hrough each
bracket m ount ed in st ep 1, and t hen secure
it t o a w all or a pillar, et c.
6
-GB Get t ing St art ed
Downloaded from: https://www.usersmanualguide.com/
For cust om ers in Japan and t he U.S.
only
Using t he support belt s (not supplied)
You can also use the BLT-R10 support belt for the
monitor stand (not supplied) to secure the monitor.
We recommend you use the SU-90 monitor stand with
which the support belts are supplied.
About t he SU-90 m onit or st and (not supplied)
The dimensions of the stand are 1,050 x 700 x 630 mm
(41
Before you purchase this stand, refer to the dimensions
above and check the size of the area where the stand
will be installed.
Bracket (supplied)
/ x 27 / x 24 / inches) (width/height/depth).
3 5 7
8 8 8
Customers in Japan should use the stand SU-90T.
Customers in the U.S. should use the stand SU-90U.
Rear
Front