Sony KL-X9200J Manual De Instrucciones página 7

St ep 2: Hookup
Before making the connection, turn off the power and
disconnect the AC power cords of the monitor and the
equipment to be connected. Refer to the instruction
manual of the equipment you connect.
Connect ing t o an IBM PC/AT or
com pat ible com put er
Connect the RGB 2 IN connector on the front or the
RGB 1 IN connector at the rear of the monitor to the
video output of the computer using the supplied RGB
signal cable (D-sub 15 pin ˜ D-sub 15 pin). Use an
audio connecting cord (not supplied) for the audio
connections.
Using t he f ront RGB 2 IN connect or
Front of the monitor
RGB signal cable
(supplied)
HD15–HD15 adaptor
(supplied)*
M ale side
(w ithout the No.9 pin)
to video output
Downloaded from: https://www.usersmanualguide.com/
RGB 2 IN
S VIDEO
RGB
AUDIO
or
Audio connecting
cord
(stereo miniplug ˜
stereo miniplug)
(not supplied)
to audio output
IBM PC/ AT or compatible
computer
Using t he rear RGB 1 IN connect or
Rear of the monitor
RGB 1 IN
AUDIO
R L
RGB OUT
AUDIO
R L
Audio connecting
cord (phono plug
× 2 ˜ stereo
miniplug)
(not supplied)
to audio output
IBM PC/ AT or compatible
computer
* The HD15–HD15 adaptor (supplied) may be needed for some
models. The male side (without the No. 9 pin) of the adaptor
should be connected to the computer.
For cust om ers using t he supplied HD15–HD15
adapt or
This monitor uses a No. 9 pin in the video signal
connector for DDC1 and DDC2B compatibility.
Some PC systems which are not compatible with either
DDC1 or DDC2B may not accept the No. 9 pin. If you
are not sure whether your PC system accepts the No. 9
pin or not, use the HD15 (Female) – HD15 (Male
without the No. 9 pin) adapter (supplied).
RGB
RGB
RGB signal cable
or
(supplied)
HD15–HD15 adaptor
(supplied)*
M ale side (w ithout
the No.9 pin)
to video output
7
Get t ing St art ed -GB
GB