Klarstein AMAZONIA 6 SMART Manual De Instrucciones página 48

EN
48
INSTALLATION
Preparation
• Place the appliance near a water inlet or drain and a power socket.
• Make sure that the hoses and the plug are accessible at all times.
Setting up the unit
Place the unit in the preferred location. The back should face the wall, the sides
towards the built-in cupboard or a wall. The dishwasher is equipped with a water
drain that can be directed to the right or the left to facilitate installation.
Power connection
Do not use an extension cord or adapter. Make sure that the socket is earthed
and complies with local regulations. Only connect the appliance to sockets that
correspond to the specified voltage of the appliance. If the plug does not fit the
socket, have it replaced by a professional.
Attach and remove the water inlet
Use new hoses for the connection. Do not use old hoses. The water pressure must
be between 0.04-1 MPa. If the pressure is lower than this, ask a specialist company
for advice.
• Attach the inlet hose: Completely unwind
the safety inlet hose from the bracket on the
back of the appliance. Attach the screw to a ¾
inch water tap. Turn on the water supply fully
before use.
• Remove the supply hose: Close the water
supply. Unscrew the inlet hose from the water
tap.
Note: Make sure the screw is tight on the tap. If you have never used the
connection before or have not used it for a long time, drain some water
beforehand until clear water comes out of the tap. These precautions ensure
that the inlet valve does not become clogged or damaged by particles in the
water.