Klarstein AMAZONIA 6 SMART Manual De Instrucciones página 72

EN
72
Problem
The glass is fogged up.
Black or grey stripes on
dishes
Detergent residues in
the chamber.
Error codes
For some faults, the display shows an error code to warn you:
In the event of a malfunction, the dishwasher displays an error code. The following
table lists possible error codes and their causes.
Code Meaning
E1 Long water inlet time.
The required
E3 temperature is not
reached.
E4 Overflow
Fault in the
communication
Ed between the main
board and the display
board.
• If the appliance overflows, turn off the main water supply before calling the
service centre.
• If there is water in the bottom tray due to overfilling or a small leak, the water
should be removed before restarting the dishwasher.
• If an error code occurs that cannot be rectified, contact the manufacturer,
customer service or a qualified specialist company.
Potential cause
Combination of soft
water and too much
detergent.
Aluminium parts have
rubbed against the
dishes.
The dishes are
obstructing the
dissolution of the
detergent.
Potential cause
The tap is not open, or the water supply
is restricted, or the water pressure is too
low.
Malfunction of the heating element.
One element of the dishwasher is leaking.
Open circuit or interrupted wiring for
communication.
Solution
Use less detergent
and use the shortest
programme to wash and
clean the glass.
Use a mild abrasive
cleaner.
Load the dishes carefully
into the dishwasher.