Publicidad
Idiomas disponibles
Idiomas disponibles
EN
64
SETUP AND OPERATION
Starting a programme
1.
Pull out the basket, load the dishes and slide the basket back into the
dishwasher.
2.
Fill in the detergent.
3.
Plug the power plug into the mains socket. For power supply details, see the
"Technical data" section and the product data sheet. Make sure that the water
supply is set to full pressure.
4.
Close the door and press the on/off button to switch on the appliance.
5.
Select a programme, the indicator light lights up. Then press the start/pause
button and the dishwasher will start the selected programme.
Change programme
A programme can only be changed if it has only been running for a short
time, otherwise the washing-up liquid may have already been released or the
washing-up water with the washing-up liquid may have been drained. In this
case, the dishwasher must be reset and the detergent holder refilled. To reset the
dishwasher, proceed as follows:
1.
Press the start/pause button to pause the rinsing process.
2.
Press the programme button for more than 3 seconds to put the machine in
programme selection mode.
3.
Press the programme button to select the desired programme.
4.
Press the start/pause button. After 1 second, the dishwasher starts.
3 sec.
Publicidad
