Safety information
¾ Never move the mower over gravel with the
motor running. You may be hit by stones!
¾ Where possible do not mow the lawn when
the grass is wet.
Mowing on steep slopes
¾ Ensure you have secure footing and mow
slowly.
¾ Always mow across the slope and not up and
down.
¾ Exercise particular caution when changing
direction. Risk of tripping!
¾ Do not mow on very steep slopes.
After use
¾ Switch the lawnmower off and store it in a
secure location.
¾ If you need to clean or service the
lawnmower, switch it off, pull out the mains
plug and remove the grass collector.
¾ During maintenance work make sure that
you do not trap your fingers between moving
cutting blades and fixed parts of the machine.
¾ Note that the cutting blades can still be
moved during maintenance even if the power
supply is switched off.
¾ Ensure that ventilation slots are free from dirt.
¾ Store the lawnmower out of reach of children.
¾ Do not repair the lawnmower yourself; it must
be repaired by a qualified expert or workshop.
¾ Allow the motor to cool before putting the
mower away.
Electrical safety
Electric shock due to cable damage!
A fuse/circuit breaker will not always
blow/trip if the cable is cut through or
damaged.
¾ Do not touch the cable before the mains plug
has been pulled out of the socket.
¾ Damaged cables must be repaired by a
qualified electrician or workshop. Repair of the
cable using insulating tape is forbidden.
Safety information
¾ Fasten the connection cable to the strain-
relief and do not allow it to rub on edges,
points or sharp objects.
¾ Do not crush the cable in between door and
doorframe or window and window frame.
¾ Do not remove or bypass any switching
devices (e.g. taping of the safety lever to the
handle).
¾ The mower should be operated via a residual
current device (RCD) with a tripping current of
no more than 30 mA.
¾ For outside use, use only approved and
appropriately labelled connection cables, e.g.
H07RN – F 3 x 1.5 mm
¾ The connector parts of connection cables
must be splash-proof and made of rubber or
rubber-coated.
General safety instructions
¾ Spare parts must meet the requirements of
the manufacturer. Therefore use only original
WOLF-Garten spare parts or spare parts
approved by the manufacturer. When replacing
spare parts, always observe the supplied fitting
instructions and always pull out the mains plug
before starting work.
¾ Repairs must only be performed by a qualified
expert or workshop.
¾ To ensure safety replace worn or damaged
parts.
¾ This lawnmower is intended for the care of
grass and lawn areas in private households.
The lawnmower must not be used for other
purposes because of the risk of bodily injury to
the user or other persons.
¾ Only use the lawnmower in daylight or under
bright artificial light. Keep your work area clean
and well illuminated.
¾ Only use the lawnmower in dry weather
conditions. Keep it away from rain or damp. The
ingress of water into the lawn mower increases
the risk of an electric shock.
(max. 25 m).
2
EN
21